WD Discovery is an application from WD that enables you to: If the router was supplied by an Internet Service Provider (ISP), please contact them for support. Please consult the router's user manual or contact the router's manufacturer for support. Western Digital does not provide instructions on how to modify the DNS settings for third party routers. Supported WD Apps, File Systems, Operating Systems, & LanguagesĪn active Internet connection with ports 80 and 443 available are required for software and firmware update notifications to occur. Turn Off Notifications, Stop on System Startup, & Unpin Menu Bar Turn on / off UAS (USB Attached SCSI) on My Passport SSD / Go Install Paragon Driver on Windows & macOS (WD Security, WD Drive Utilities, Acronis Backup) If it is not then double-click on the name and set it to automatic and started then reboot the machine.Set a Password & Unlock a Supported WD DriveĬonfigure RAID Mode (Direct Attached Drive).Verify that the Status is Started and the Startup Type is Automatic. ![]() One the left-hand side click on Services and Applications then click on Services.If the drive is still not showing in Windows Explorer check the service:.Leave the computer management window open and check Windows Explorer.Select Add then assign a drive letter to the drive and click okay.Right-click the middle box where you see NTFS and select change drive letter:.If your drive shows similar but without the drive letter try adding a letter: The drive should look similar to the example below: In the middle of the screen towards the bottom look for the Disk number located on step 5.On the left hand side select Disk Management.Locate the Disk number then close the window.When the new window opens select the volumes tab and at the bottom select populate.If the drive is detected there - Double-click it.In the device manager window expand ‘Disk Drives’.Once the computer management screen opens locate device manager:. ![]() That will bring up the run box and type - compmgmt.msc.If the driver is installed but the drive is still not showing check computer management:.Check control panel - Add and Remove or Programs and Features depending on Windows version.Verify that the Paragon HFS+ for Windows is installed.Note: The driver will not work if the drive was encrypted on your Mac. If you are having issues with the drive being detected try the following steps. Installing the Paragon HFS+ driver will give you the ability to see your HFS+ formatted drive. Locate manufacture and make sure Seagate is listed like the example below:.In the middle locate your Seagate drive - Select it. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |